Compression is one of the most useful tools in any engineer’s armory, without which tracks can sound thin and unbalanced. However, used incorrectly and it can also destroy your tracks making them sound flat and uninteresting. If you’re new to compression then the best approach is to use caution until you get used to the controls and the ‘sound’ of compression. This is particularly the case for instruments with a lot of attack like acoustic guitars as compression can unnaturally flatten these, taking the life out of the sound.

In previous tips I’ve talked about how to use traditional downward compression to make vocals sit right in a mix and I suggested that you could try compressing in stages using one compressor to as transparently as possible control the peaks and a second to gently lift low end detail whilst allowing the already compressed peaks through. This technique can work well for instruments too, but there is also another, less common approach which can be even more effective and allow greater compression without negative audible side-effects.

Parallel compression, involves mixing in a compressed copy of an instrument with the original, the idea being that the transient peaks of the original are retained but the low level detail is brought up to give a thicker sound. When the level drops below the threshold on the compressed channel, this copy will be adding to the original and boosting the overall level. Then when there is a peak and the compressor kicks in the signal is compressed and adds less to the overall level. Mixed in at the right level this compressed copy can create extra thickness, without adding significantly to the peak level of the instrument.

There are some technical requirements to make this work. The compressor on the copy must not introduce any time delay or the signal will be out of phase with the original. If you’re trying this in something like Cubase or Logic make sure that plug-in delay compensation is switched on. The other requirement is that the compressor is peak sensing and can have a 0ms attack time. Without this peaks will pass through on the copy and add to the peak level.

In practice, make a copy of the instrument’s audio file on a fresh track and apply a compressor plugin to this copy. Set the attack time to 0ms and the release to around 250ms+ A ratio of 2:1 works well and you should be aiming for around 4-5dB gain reduction on the peaks (automatic gain make-up should be off). Now play the two tracks together and slowly fade up the compressed copy to find a level which works well (usually somewhere between -15dB to -5dB). Hopefully the effect is that the combined peak level has barley risen, but the instrument sounds fuller and has retained its original attack.

Quality Music radio: DATABLENDER FM

4410
Tv

PressPausePlay

5229
Tv

How to create wide open mixes

6853
Production

Seven ways to reduce noise

8714
Production

Mixing - the 12 step program

8111
Production

Arrangement 101

5643
Production

Tips for mixing the low end

5894
Production

The audible frequency range

6320
Production

Mastering basics for musicians

7472
Mastering

10 questions about mastering your recordings

5873
Mastering

Preparing your mixdown for mastering

5688
Production

Tips for mixing for vinyl

9921
Production

Gez Varley

7036
Interview, synthience

Viktoria Rebeka

5402
Interview, synthience

Andy Wonderland

4898
Interview, synthience

Andrea Suglia

5372
Interview, synthience

Mikrokristal

6317
Interview, synthience

Luke Hess

5721
Interview, synthience

Stereo editing and mastering

5904
Mastering

Preparing music for mastering

5885
Mastering

How the professionals do it

5537
Mastering

Audio mastering in your computer

6074
Mastering

T-Racks mastering audio techniques

10810
Mastering

Digital audio editing

5944
Production

6 mono to stereo methods

5547
Production

Outboard processing

5445
Production

Mixing on headphones

5897
Production

Using the side-chain

4985
Production

Watch your levels

5175
Production

Parallel compression

5719
Production

The sub-kick trick

6536
Production

5 perspective tips

5292
Production

Vocals in the Mix

5365
Production

Panning Tips

5961
Production

Using Compression

5348
Production

Tech Talk - Sherman Filterbank

7620
Tv

Tech Talk - Funktion One

6735
Tv

The Creation of Techno Music

5983
Tv

Mixing for vinyl record

6025
Production

20 tips on home mastering

6947
Mastering

18 ways to give your music groove

8479
Production

23 tips for better home recordings

7769
Production

48 ambient production tips

14287
Production

30 EQ techiques

9300
Production

35 music production pro tips

9565
Production

Pre master levels

11229
Mastering

9 mastering tips for beginners

9789
Mastering

20 tips on music mixing

8382
Production

8 synthesis tips for beginners

7674
Production

Your guide to frequency

16271
Production